Search results

FOR SALE: 2004 NSR50 - Bike is fully stocked - Bill of sale in hand (not street legal) - Engine rebuilt early 2018 (few hours on motor since it rains so much in Oregon ��) - Comes w/sprockets/jets I have for it - Bike tuned up in April 2020 (oil, fluid etc) - Motor still strong...

I have been trying to tune my sons NSR50 but can't seem to find the sweet spot, it has very poor acceleration which causes him to keep the throttle at VERY high RPM's through turns, definitely doesn't help at the starting grid either. His bike is fully stocked, no modifications at all. The...

For Sale $100.00 firm Size: really not sure? It fit perfectly on my son when he was 52-53 inches tall. Color: Black and Red Type: GMOCO Suit has no holes but a couple of scratches, of course, from minor falls. Comes with kids gloves which was hardly worn and looks brand new. Son has out grew...

For Sale $100.00 firm Size: really not sure? It fit perfectly on my son when he was 52-53 inches tall. Color: Black and Red Type: GMOCO Suit has no holes but a couple of scratches, of course, from minor falls. Comes with kids gloves which was hardly worn and looks brand new. Son has out grew...

Looking for a used aftermarket racing exhaust and carb for an 04" NSR. The bike is completely stock and I would like a little kick in it. thanks in advance..

Looking for a rear rim for a ysr50. Any color and not necessary to have rear tire. Thnx in advance

I'm tryin to purchase a carb and have seen several makes and models for my KX motor. Seen some on eBay that range from the high $200 to low $100. So does it really matter what make and model it is? Will the expensive one perform the same as the low end models? If they have the same specs...

Hello- i'm trying to figure out what would be the best break in procedure for a 97 KX100 motor with a new top end. I have searched the web but i have not seen anything specific to the motor. Any help would be greatly apprcieated. thanks in advance,

Hello- I got the motor (KX80) rebuilt last year and ran it in one event. Performed the heat cycle several times to ensure break in was done properly. I tested it out on Saturday and for some reason it doesn't feel the same as it did before the rebuilt. The high end as well as the low end is not...

Hello- Looking for some gear for my 5yr old son. Any gear for sale pls let me know. Thanks in advance, Sonny

Having trouble down shifting into 1st gear with my KX85 motor. Sometimes it doesnt go into 1st eventhough I rev the motor. All other gears are fine. Would this be the clutch or internal gearing?? thanks in advance for the reply!!

Want to know what else I can do to a stock KX85 motor to gain more speed. thanks in advance, :thumbup

Ayone have a internal picture of a carb for an 80 motor. Everytime I open my throttle the slider keeps turning causing the motor to rev. Not sure if there was a pin to keep the slider in place? Any help will be appreciated. thanks,

Anyone know where I can take my RS80 to race in Oregon?? Thanks in advance..

I replaced the battery on my 06" Kawasaki 636 and for some reason the "Fuel light remains on and the bike wont start? I checked the fuel line and it seems fine and is not pinched anywhere. The bike just tends to crank up but wont turn over and start.. Has this issue happen to anyone else...

anyone going to Buttonwillow this weekend!?! wondering how the turnout will be?!

What days are open for mini moto practice @ stockton? Trying to go and test out the bike... Thanks in advance :) Sonny SMRRC #62

Looking for the following parts for an RS80 -Spedometer -CR80 Main Jets and Pilot Jets -Rear sets

Need help. What size/range sprocket and jet to use at Stockton for an RS80? Pilot Jet? Main Jet? Thanks in advance, Sonny M

Looking for a complete tach and temp gauge for a 93" RS80/125. Fully functional and good condition. Sonny