R3DS!X
Whatever that means
Thanks to everyone for their input and advice and parts!
Before shots:
Kinda hard to see how bad the bike was before but she was definitely rough around the edges. A blind man would be happy to see her.
After:
Short list of things I did:
Clean and degrease the things that shouldn't be greasy
new tires,
Calipers from a CBR600f4I
Brembo Master on the front thanks to barfer demoni
Stainless lines
front brakes bled
LED bulb
Front end resprung and revalved and serviced by SPS
front fender, forks, radiator sides and back of gauge cluster coated in Truck Bed liner.
Radiator flushed and new coolant added.
Oil and filter changed
Charcoal canister and AIS system removed and blocked off
Aftermarket chinese rearsets from danmoto
Twin carbon pipes also from danmoto
Rear fender delete that I 3D printed
Installed integrated tail light and turn signal unit
Rear grab bar block off plates thanks to barfer McGrude
Lamb sacrificed to the elder gods
Seat recovered
Nitron rear shock
rear stainless line and fluid flushed and bled
Air filter replaced and flapper valve removed
New handle bars
New grips
Bar end mirrors
Clutch lever replaced with fancy chinese crap
painted rust inhibiting paint on lower triple
phone mount
Fancy cheap gas cap
Sticker bomb design along tail and top stripe of tank
tank grips and pad
Other minor things
I say it's done but really I've got a little bit of fiddling left but it's up and running and close enough to done. If you're curious about the progress I half assedly documented things in this thread: https://bayarearidersforum.com/forums/showthread.php?t=542072
Before shots:
Kinda hard to see how bad the bike was before but she was definitely rough around the edges. A blind man would be happy to see her.
After:
Short list of things I did:
Clean and degrease the things that shouldn't be greasy
new tires,
Calipers from a CBR600f4I
Brembo Master on the front thanks to barfer demoni
Stainless lines
front brakes bled
LED bulb
Front end resprung and revalved and serviced by SPS
front fender, forks, radiator sides and back of gauge cluster coated in Truck Bed liner.
Radiator flushed and new coolant added.
Oil and filter changed
Charcoal canister and AIS system removed and blocked off
Aftermarket chinese rearsets from danmoto
Twin carbon pipes also from danmoto
Rear fender delete that I 3D printed
Installed integrated tail light and turn signal unit
Rear grab bar block off plates thanks to barfer McGrude
Lamb sacrificed to the elder gods
Seat recovered
Nitron rear shock
rear stainless line and fluid flushed and bled
Air filter replaced and flapper valve removed
New handle bars
New grips
Bar end mirrors
Clutch lever replaced with fancy chinese crap
painted rust inhibiting paint on lower triple
phone mount
Fancy cheap gas cap
Sticker bomb design along tail and top stripe of tank
tank grips and pad
Other minor things
I say it's done but really I've got a little bit of fiddling left but it's up and running and close enough to done. If you're curious about the progress I half assedly documented things in this thread: https://bayarearidersforum.com/forums/showthread.php?t=542072
Last edited: