Paint booth

[dravnx]

I want to build a paint booth for small parts. 4X4X4. It will be up against an outside wall for venting. Looking for ideas.

 

[budman]

Something like THIS work??

 

[dravnx]

Too small. It's 2'W

 

[kingmoochr]

1x1s and plastic sheeting? Are you installing a duct in the wall to the exterior?

 

[scootergmc]

Cheap and easy or somewhat permanent? I'm somewhat partial to an EZ-up with the sides wrapped in plastic sheeting but your options are almost limitless with PVC pipe and plastic sheeting.

 

[dravnx]

I've got some OSB and a plenty of lumber to use and want it permanent.
4'X4'X4' with outside exhaust.

 

[auntiebling]

box fans blowing over your part with heater filters to clean the air.

there are tons of hits on this with interweb searches.

 

[Enchanter]

Since it’s permanent, cover the interior with removable tear-off sides. Makes for easier clean up after multiple jobs.

Pretty common for full-size pain booths now too.

 

[Arsey]

Been thinking of buying one of these when I reach the point of painting in my latest resto:

https://www.amazon.com/dp/B07LDNL7GF/ref=cm_sw_r_cp_api_fabc_wSVTFbMG4N5C9?psc=1

Probably cheaper than you can buy the materials to build what you’re thinking of, and it’s bigger and better with the added convenience of being able to deflate and roll it up when not using it.

 

[Shaggy]

I built one a few years back with 3” PVC, plastic sheeting and a box fan. Pretty easy to set up and take down and fit nicely inside my garage when assembled. I used it to paint some fiberglass bodywork for my old race bike and when I was done I disassembled and stuffed on the top shelf in my garage.

 

[TylerW]

I know you've already mentioned that you want it to be permeant - But I've really enjoyed using these pop-up versions.

https://www.amazon.com/Nordstrand-P...jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ==