hyper clutch

[2strokebendejo]

howdy newish to me 08 hypermotard 1100 Im not super familiar with this motor but the clutch seems to slip when i clutch it up in 2nd or 3rd.
had a shop check it out they said its within spec( i assume they measured the plates)
did the old 6th gear with a pillion roll on and i feel its slipping
bike has 17,xxx miles has seen a couple track days

plates warped? should i replace or anything else? thx

 

[kuksul08]

Make sure your clutch master is not plugged. There's a fine passageway to release fluid pressure and if it's clogged it will still be applying some pressure to the clutch pack and cause it to slip.

 

[2strokebendejo]

thank you sir ducatis are new to me
how do i check it?

edit Ill stop being lazy and google it
Ill take any tipstho

 

[kuksul08]

thank you sir ducatis are new to me
how do i check it?

Take off the master cylinder cap and look inside if you can. If it's a radial type then I'm not sure how to help.

http://www.ducati.org/forums/848/62885-possible-clutch-issues.html

 

[2strokebendejo]

Ya it is. Been looking at all forums. Thx!!

 

[2strokebendejo]

Ok. Flushed fluid
Still slipping. Pulled clutch. Fibers are beyond worn
Bought new plates but this is my 1st Ducati

From what I understand pretty straight forward besides 2nd steel disc put in basket is the thinner disc with the "D" stamp facing out
Any other tips?
Oem clutch pack
Thx!!

 

[2strokebendejo]

I can't find much info on the procedure

 

[Haket]

If you were able to pull the plates, that's the hard part done. Just put them back in the same order they were removed. Tighten springs in a criss cross pattern. Don't pull the clutch lever when the pressure plate is off.