dissemble a fork cap

[Ricebowls]

I'm trying to dissemble the stock for cap on a 07 GSXR 600 so I can install a fork cap extender. I've removed it from the bike and separated the rebound rod but I can't figure out how to remove the preload adjuster. Any help is appreciated.

 

[Wicked4Racin]

Small metal circlip on the bottom side. Take it off and the cap will separate from the valve/adjuster. Silver clip, can't miss it. But for some reason I did one time it and cost a new fork cap. Don't pry or go crazy. Its alum

 

[Ricebowls]

Thanks, I'll give it a shot.

 

[Tri750]

What the heck is a fork cap extender?
I may need some one day.

 

[Hooli]

They allow you to lengthen the overall fork. Then you can raise the front end (along with the rear) for improved overall handling. It's a common trick among racers and serious track day riders. :ride

 

[afm199]

Small metal circlip on the bottom side. Take it off and the cap will separate from the valve/adjuster. Silver clip, can't miss it. But for some reason I did one time it and cost a new fork cap. Don't pry or go crazy. Its alum

Absolutely totally this. Be very careful with those GSXR fork caps. If you force one you may need to find a new one.

 

[Ricebowls]

I got the circlip off but still no luck. I'm reluctant to crank on it but seems like that;s the only way to get it off.

 

[stangmx13]

What the heck is a fork cap extender?
I may need some one day.

some bikes need a lot of extra fork length for good track geometry. most aftermarket fork cartridges lengthen the forks ~10mm. u gotta install extenders when u need more than that. ive only seen these on certain GSXRs

 

[afm199]

I got the circlip off but still no luck. I'm reluctant to crank on it but seems like that;s the only way to get it off.

There's a flat plate with a threaded hole in it that backs up against the body. Look.

 

[Ricebowls]

Brought it to Jim at Catalyst. Turns out the cranking on it GENTLY was the way to go. it was just tight.