R3DS!X
Whatever that means
So my DR350 I picked up initially wasn't running, it would start and run but only with choke. Pilot jet turned out to be occluded, so rebuilt the carb.
now she starts with choke and after a few seconds idles fine, starts and accelerates fine, BUT intermittently when I try to maintain speed she sputters and stalls like she is running out of gas. pretty odd. I speak carburetor conversationally but I'm not fluent. I looked around to make sure there weren't any hoses disconnected or something not seated but AFAIK everything is proper.
Could it just be the AF screw? I set it to 2 turns out as was recommended by the innerwebs. I hope I don't have to fiddle with that cause it's in a bitch of a spot and I have to pull the carb to get to it basically.
Could it be bad gas or too high of an octane? i used 91 in it but maybe a lower octane would run better?
FANKS
now she starts with choke and after a few seconds idles fine, starts and accelerates fine, BUT intermittently when I try to maintain speed she sputters and stalls like she is running out of gas. pretty odd. I speak carburetor conversationally but I'm not fluent. I looked around to make sure there weren't any hoses disconnected or something not seated but AFAIK everything is proper.
Could it just be the AF screw? I set it to 2 turns out as was recommended by the innerwebs. I hope I don't have to fiddle with that cause it's in a bitch of a spot and I have to pull the carb to get to it basically.
Could it be bad gas or too high of an octane? i used 91 in it but maybe a lower octane would run better?
FANKS
Last edited: