Recent content by Z3n

$8200 63.7 hours Street legal, currently registered. OEM 6 Days parts: Plastic Skidplate Solid rear rotor 6 Days pads Preload adjustable fork caps Billet triples Gripper seat Aftermarket parts: Blais Smog blockoff kit Scotts Damper (Sub mount) / Vibration Damping Mounts / Cycra Handguards...

2013 ZX6R Salvage title, current registration - no street parts, but wiring harness / key is intact. TC model, works wonderfully on track. No ABS. ~4k miles $4800 - 1% to Barf if sold here. Ohlins 30mm cartridges Ohlins TTX shock Leo Vince full system Power commander 5 / Autotune...

Anyone know of a way to check on if the rider was okay? https://cad.chp.ca.gov/traffic.aspx We had waved to each other about 30 seconds before the accident :( I didn’t see anything, just rider on the ground, not moving.

Turns out after some additional research, I'll need one of these too. Anyone got one they're trying to unload? Same routine as my other thread - blown engines, etc, fine, preferential to S models with the uprated suspension and the like.

Would be using this for a street project, blown motor is fine. Bonus points for upgraded suspension, lightweight wheels. Most everything will be custom, so as long as the rolling chassis is in good shape and the price is right, open to anything. Cosmetic damage is fine, salvage titles are...

Free motor. 60k miles. Hops out of 3rd gear. Ran when pulled. You pick it up. Doesn't have a stator cover at the moment, otherwise all there. Has Ivan's block off plates.

Carbon Yamaha R1M fairings, good condition, usual nicks and scratches from use. Never been crashed. Side fairings and upper. $1200 Yamaha 2016+ FZ10 wheels, neon yellow, new OEM wheels without bearings / spacers/rotors/etc: $400 for front and rear. Will fit new R1 models as well (OEM wheels on...

https://newatlas.com/ntsb-recommends-mandatory-abs-traction-motorcycles/56424/ Glad to see the US finally getting on board with this sort of common sense stuff.

Looking for a track prepped 2015+ Yamaha R1. Must be able to take it back to street legality, although I don't need it to be street legal as it sits. Willing to pay more if you have full suspension, autoblipper, case savers, etc. Crashed or salvage titles not a problem as long as you have...

Lookin for the above - roughly looking to spend about 2k at the top end.

The commuting mindset is the most conservative, risk averse, and safe of the mindsets I use to approach riding. There's a couple of other ones (spirited street, track, offroad, and supermoto all come to mind), but this one is the broadest and the most useful and accessible to other riders, so...

2014 KTM SuperDuke 1290 $10,000 ~22k miles Clean title Decided after riding only a minimal amount over the last couple of months it's time to let the SuperDuke pass on to someone who's going to ride it more. It's been to half a dozen trackdays, rest of the miles are street miles. Bike has been...

Bike didn't gell with the rider, so machete's old racebike is back up for sale. $2700, clean title, currently registered, pink in hand. Since it was listed it's gone to 2 trackdays, and has a set of Pirelli SuperCorsas. It's also been wired for street legal running - working brake light, LED...

Doing the CBX project, need to pull transmission bearings to treat the transmission shafts - however, they're oddball bearings, with an offset hole for a locating dowel and oil holes in the outer race. If possible, I'd like to remove them without damage and reuse them. Anyone have a...

Finally getting around to starting this project - I found a craiglist bike for relatively cheap, and a buddy commissioned me to build him a restomod CBX. Here's what we started with: I sent the carbs off to Jack at Old school carbs to get rebuilt properly, as they were seized and terrible, and...