Hi,
Where do you South Bay denizens get materials for projects? Metals, steel, Al, brass, stainless, plate, bar, extrusions, tube, new and odds and ends.
Cheers
Lou
Hi,
I am puttnig in a set of SS lines on my gsxr front end on my sv. The lines are much stiffer than the original hose. I am concerned that if I use the clip on the side of the fender the curves might be tight when the front end gets loaded. Do people leave these floating from the banjo bolt...
Hi,
I need to remove the bearings on the front wheel of a GSXR-600/750. Manual says to use special tool xxx. I have a 3-jaw bearing puller but it does not get a purchase because the spacer between the bearings is too flush. Suggestions? I'm considering putting an internal snapring in there to...
I am riveting a chain. The master link is the type with hollow pins. I rivet it with a steel ball in the riveting tool. The question: How much spread do I have to achieve in the diameter of the pin for a safe link? .01mm? .02mm? More?
Cheers
Lou
Hi,
Anyone used these? Anyone used these on a 2nd gen SV650 in street trim?
Anyone have recommendations for good radiator repair in South Bay?
Thanks.
Cheers
Lou
Anyone else think that the design of the kickstand prong (to flip it out) is horrendous? So difficult to get to between the gear shift lever and footpeg. Actually easier for me to flick it from the ground contact part. Anyone mod this thing?
Cheers
Lou
(Hey, it's about fixing -something- moto related.)
Does anyone have a location to get YKK zippers? I have to fix one damaged in an off at BW. I know that they have some kind of offices locally, but do they have reatail? Thanks.
Cheers
Lou
Hi,
I am looking for right side fairing and headlight enclosure (incident at Buttonwillow on Monday), could be the complete set depending on price.
Cheers
Lou
Hi,
I'm looking to flesh out a concept for a new project and was looking for some input. The project is for a two-up machine with a flat seat and comfort for the pillion. Said pillion was happy aboard a CB400F, not so much aboard an SV650 (too high, seat to footpeg distance too short). I was...
Hi,
I have no idea for a route, but just want to get out there. 6:30 start from Saratoga 76 sound OK? One I was in a few week ago was fun. Who's in?
Cheers
Lou