Search results

So I was on my FZR on my way to work. Halfway through my commute, the bike would sputter every so often like it's losing power for a moment; the RPM would go up and down with it. Then it would be fine and run strong. Well, as I got near work, it started sputtering again (holding the throttle...

So my laptop is giving me this error: PXE--E61: Check media cable, then fails to boot up and tries to reboot. From my understanding there is potentially an issue with the HD. Now I tried to run the system HD disk check, but it is saying that no IDE device is found. So is there anyway to check...

So I bought a set of Woodcraft rearsets (peg and lever kit) for the duc. I finally get it, but find that the shouldered bolt that holds the pegs and levers together doesn't come with it. I emailed them and they replied saying that the kit assumes that I have stock rearset. Well, I bought...

So the stock wheels on the fzr is getting quite dirty (tar, rubber??) and am having a tough time getting rid of it without messing up the paint/powdercoat. Would the integrity of the wheel suffer if I remove the powdercoat? If not, what's the cheapest/easiest way to do this? I was thinking of...

Does anyone know where to get bearings for the rear wheel? And how much do they cost? I saw some over the web from $20 to $70+. What should I be looking for as far as rpm and load? TIA

So I was heading home on the carpool lane on 85 (before hitting the 280N exit) on the duc, when another rider came up to my right. I knew he was there somewhere as I saw him about to merge to the carpool lane. As he came up to me, he said something about the bike. I thought he said something...

So my duc seems to be going through fuses (7.5amps) like crazy. Everytime I take it out, the same damn fuse goes out; this is for the turn signal, horn and cluster lights. So I figured, I've got a short somewhere in that circuit. I tried checking the ends where it's easily accessible, and it...

Ok. So I decided to freshen up the duc. I installed an Evoluzione slave cylinder and a Barnett Clutch Kit. A couple of things happened. That famous "spoon in the garbage disposal" sound that duc's are known for, is now gone!! I was wary at first, but I could tell that the system was working...

I've seen movie shots in the photo section (and others) that looks like they are taken from DVD's. Can anyone tell me how to do this? I tried using printscreen, but that didn't work. It only showed the Interactual frame but no picture from the movie. TIA

Just to show, it's not just the young with hyper 600s. Boils down to inexperience and misjudgements. By DAVID SHARP, Associated Press Writer PORTLAND, Maine - Safety experts suspect older motorcycle riders with a lot of disposable income are buying more machines than their aging...

Ok. So here I was pulling over to let the ambulance through when the bike started feeling strange. When I was ready to go, the bike wouldn't move!! WTF!! Turns out the front brake was locked. I could feel that the brake lever was stiff so I took the cover off the master cylinder hoping to...

I need help bad!! Recently, my 92 FZR 600 has been acting up. When I turn the key and the switch on, all the electricals seems fine. But when I hit the ignition switch...it goes fzzzt! and dies. The engine doesn't turn or anything. After turning off the electricals and kill switch and...

I've been lurking around for a couple of weeks now so I've decided to join in the "fun".:laughing